Rubber Stamps Assembly Instructions

List of Parts:

A. Plastic Housing

B. Rubber Die

C. Label

1. Hold your stamp so the clear cover of the housing is facing the ground and the Vistaprint logo is upside-down and facing you.

2. Push the top and bottom of the housing together until you see the yellow strip. Squeeze the buttons located on each side until the housing locks in place.

3. Peel the yellow strip to uncover the adhesive. Place the smooth side of the rubber die on the adhesive. Make sure the rubber die is straight. Caution: once the rubber die is stuck on the adhesive, it cannot be removed.

4. Push down on the housing to release the lock. Stamp your paper label with the shorter end facing you. (We recommend that you test your stamp on another piece of paper first.)

5. Unsnap the clear cover from the housing, insert your label and replace the clear cover.

List of Parts:

A. Plastic Housing

B. Rubber Die

C. Ink Cartridge

1. Remove the cover from your pocket stamp.                                                        

2. Hold your pocket stamp so that the yellow strip is facing upwards.

3. Peel the yellow strip to uncover the adhesive. Place the smooth side of the rubber die on the adhesive. Make sure the rubber die is straight. Caution: once the rubber die is stuck on the adhesive, it cannot be removed.

List of Parts:

A. Plastic Housing

B. Date Wheels

C. Rubber Die

D. Ink Cartridge

E. Label

1. Hold your stamp so the clear cover of the housing is facing the ground and the Vistaprint logo is upside-down and facing you.

2. Push the top and bottom of the housing together until you see the yellow strip. Squeeze the buttons located on each side until the housing locks in place.

3. Adjust the date while the housing is in the locked position by rotating the wheels. Rotating the wheels in the locked position allows you to see the date clearly.

4. Peel the yellow strip to uncover the adhesive. Make sure your text on the rubber die falls above and/or below the date where necessary. The numbers and text will be upright and reversed. Place the smooth side of the rubber die on the adhesive. Make sure the rubber die is straight. Caution: once the rubber die is placed on the adhesive, it cannot be removed.

5. Push down on the housing to release the lock. Remove the cover on your ink cartridge. Insert the cartridge into the empty slot on the plastic housing. The ink side should be facing down.

6. Stamp your white paper label. (We recommend that you test your stamp on another piece of paper first).

7. Unsnap the clear cover from the housing, insert your label, and replace the clear cover.